C P - 5 5 0 0 CONNER NO MORE PRODUCED Native| Translation ------+-----+-----+----- Form 5.25"/HH Cylinders 2034| | | Capacity form/unform 510/ MB Heads 10| | | Seek time / track 12.0/ 3.0 ms Sector/track 49| | | Controller SCSI2 SINGLE-ENDED Precompensation 65535 Cache/Buffer 256 KB Landing Zone 2033 Data transfer rate 2.500 MB/S int Bytes/Sector 512 5.000 MB/S ext SYNC Recording method RLL operating | non-operating -------------+-------------- Supply voltage 5/12 V Temperature *C 5 55 | -40 60 Power: sleep W Humidity % 8 80 | 8 80 standby W Altitude km -0.061 3.050| 12.200 idle 13.9 W Shock g 5 | 50 seek 13.9 W Rotation RPM 4498 read/write 12.0 W Acoustic dBA 40 spin-up W ECC Bit MTBF h 150000 Warranty Month Lift/Lock/Park YES Certificates ********************************************************************** L A Y O U T ********************************************************************** CONNER CP5500 CHINOOK SERIES PRODUCT MANUAL REV. 1, NOVEMBER 1991 +---------------------------------------------------------+ | E4+++++E1 | | +++++ ++|XX | +--------+ |||XX 50-pin | +--------+ |||XX SCSI | Terminators||XX | |||XX | ++|XX | |||XX | |||XX | |||XX | Spindle Sync |||XX | LED ++|XX1 |+-+ | || | |XX || | +---------+ |XX Power |+-+ +---------+ | 1 +---------------------------------------------------------+ ********************************************************************** J U M P E R S ********************************************************************** CONNER CP5500 CHINOOK SERIES PRODUCT MANUAL REV. 1, NOVEMBER 1991 Jumper Setting ============== There are three jumpers available for configuration of SCSI ID: E1, E2, and E3. E1/E2/E3 SCSI ID ---------------- +----------+-----------------------+ | SCSI ID | Jumpers | | | E3 | E2 | E1 | +----------+-------+-------+-------+ | 0 | OPEN | OPEN | OPEN | | 1 | OPEN | OPEN | CLOSED| | 2 | OPEN | CLOSED| OPEN | | 3 | OPEN | CLOSED| CLOSED| | 4 | CLOSED| OPEN | OPEN | | 5 | CLOSED| OPEN | CLOSED| | 6 | CLOSED| CLOSED| OPEN | | 7 | CLOSED| CLOSED| CLOSED| +----------+-------+-------+-------+ NOTE SCSI Parity out is always enabled. Jumper E4 disables SCSI Parity in.