M 2 6 3 6 T FUJITSU NO MORE PRODUCED Native| Translation ------+-----+-----+----- Form 2.5"/SUPERSLIMLINE Cylinders 1574| 698| | Capacity form/unform 200/ MB Heads 5| 10| | Seek time / track 14.5/ 3.0 ms Sector/track | 56| | Controller IDE / AT Precompensation Cache/Buffer 224 KB READ-AHEAD Landing Zone Data transfer rate 2.670 MB/S int Bytes/Sector 512 8.000 MB/S ext Recording method RLL 1/7 operating | non-operating -------------+-------------- Supply voltage 5 V Temperature *C 5 55 | -40 70 Power: sleep W Humidity % 8 90 | 5 95 standby 0.2 W Altitude km -0.300 3.000| -0.300 12.000 idle 1.8 W Shock g 10 | 100 seek 2.5 W Rotation RPM 4500 read/write W Acoustic dBA 30 spin-up W ECC Bit 88-REED SOLOMON,ON THE FLY MTBF h 150000 Warranty Month Lift/Lock/Park YES Certificates ********************************************************************** L A Y O U T ********************************************************************** FUJITSU M2634T/35T/2636T JUMPER SETTING +---------------------------------------------------------+ | |XX | |XXI | |XXN | |XXT | |XXE | |XXR | |XXF | |XXA | |XXC | |XXE | |XX | |XX | |XXMaster/ | |xxSlave +---------------------------------------------------------+ ********************************************************************** J U M P E R S ********************************************************************** FUJITSU M2634/35/36T JUMPER SETTING Jumper Setting ============== Master/Slave ------------ The drive only has a master/slave setting which is configured by pins 2 & 4 of the interface connector. It should be noted that these pins are horizontally adjacent to each other. Pins 2-4 OPEN MASTER (Default) CLOSED SLAVE ********************************************************************** I N S T A L L ********************************************************************** -ANY DIREC. Notes on installation ===================== Installation direction ---------------------- horizontally vertically +-----------------+ +--+ +--+ | | | +-----+ +-----+ | | | | | | | | | +-+-----------------+-+ | | | | | | +---------------------+ | | | | | | | | | | | | | | | | | | +---------------------+ | +-----+ +-----+ | +-+-----------------+-+ +--+ +--+ | | | | +-----------------+ The drive will operate in all axis (6 directions). ********************************************************************** F E A T U R E S ********************************************************************** FUJITSU MEDIA DEFECTS Media Defects ------------- Before the unit leaves the factory, media defects are listed on the MEDIA DEFECT LIST. This list is written on the media in the SA space which is a reserved area of the disk.