Data bus:	32-bit EISA
Size:	Half-length, full-height card
Hard drive supported:	Up to seven SCSI devices
Floppy drives supported:	Two 360KB, 720KB, 1.2MB, or 1.44MB drives

CONNECTIONS
Function	Location
50-pin SCSI connector - internal	P3
34-pin cable connector - floppy drive	P4
3-pin connector - drive active LED	P5

USER CONFIGURABLE SETTINGS
Function		Location	Setting
»	64 KB PROM enabled (276512)	J1	pins 2 & 3 closed
	128KB PROM disabled (276256)	J1	pins 1 & 2 closed
»	Factory configured - do not alter	J2	pins 2 & 3 closed
»	Factory configured - do not alter	J9	pins 2 & 3 closed
»	IRQ14 for primary adapter enabled	J10	pins 1 & 2 closed
	IRQ14 for secondary adapter disabled	J10	pins 2 & 3 closed
»	Floppy drive interface enabled	J11	pins 2 & 3 closed
	Floppy drive interface disabled	J11	pins 1 & 2 closed
»	Factory configured - do not alter	J12	pins 1 & 2 closed

USER CONFIGURABLE SETTINGS CONTINUED
Function		Location	Setting
»	Primary adapter enabled	J13	pins 1 & 2closed
	Secondary adapter enabled	J13	pins 2 & 3 closed
»	Factory configured - do not alter	J14	pins 1 & 2 closed
Note: The location of J9 is unidentified. Select the primary configuration if there is only one DCE376 controller in the system. If there is more than one DCE376 (disk duplexing), configure one as primary and the other as secondary.

DRAM CONFIGURATION
Size	Bank 0	Bank 1
512K	(2) 256K x 9	none
1MB	(2) 256K x 9	(2) 256 x 9
2MB	(2) 1MB x 9	none
4MB	(2) 1MB x 9	(2) 1MB x 9
8MB	(2) 4MB x 9	none

DRAM JUMPER SETTINGS
SIMM Size	J3	J4	J5	J6	J7	J8
256KB	1 & 2	1 & 2	1 & 2	open	1 & 2	1 & 2
1MB	2 & 3	2 & 3	1 & 2	open	2 & 3	1 & 2
4MB	2 & 3	open	2 & 3	2 & 3	2 & 3	2 & 3
Note: Designated pins should be in the closed position.

MISCELLANEOUS TECHNICAL NOTES

The jumper settings in this document apply only to board revision E or later.