KOUWELL ELECTRONICS CORPORATION

KW-801

Data Bus

32-bit PCI

Card Size

Half-height, half-length card

Hard Drives supported

Up to 7 SCSI-2 devices

Floppy drives supported

None

CONNECTIONS

Function

Location

Function

Location

50-pin SCSI connector - internal

J1

2-pin connector - drive active LED

J4

50-pin SCSI connector - external

J2

 

 

USER CONFIGURABLE SETTINGS

Function

Label

Position

»

Active termination enabled

JP1

Closed

 

Active termination disabled

JP1

Open

Note: When BOTH external AND internal devices exist, disable on-board termination jumper JP1 and insert the resister array RP1-RP3. This setting is used if controller lies within the device chain. When only external devices OR only internal devices exist, enable JP1 and remove resister arry RP1-RP3. This setting is used when controller is at one end of device chain. (Location of resistors RP1-RP3 is unidentified.)

PCI INTERRUPT SELECTION

Setting

JP2

JP3

»

INTA

Pins 2 & 3 closed

Open

 

INTB

Pins 1 & 2 closed

Open

 

INTC

Open

Pins 2 & 3 closed

 

INTD

Open

Pins 1 & 2 closed