M 2 7 2 3 T A M FUJITSU Native| Translation ------+-----+-----+----- Form 2.5"/SUPERSLIMLINE Cylinders 5157| | | Capacity form/unform 1224/ MB Heads 3| | | Seek time / track 12.0/ 3.0 ms Sector/track | | | Controller IDE / ATA3 Precompensation Cache/Buffer 128 KB Landing Zone Data transfer rate 5.000 MB/S int Bytes/Sector 512 16.700 MB/S ext PIO1 Recording method PR4ML operating | non-operating -------------+-------------- Supply voltage 5 V Temperature *C 5 55 | -40 65 Power: sleep 0.3 W Humidity % 8 90 | 5 95 standby 0.4 W Altitude km -0.300 3.000| -0.300 12.000 idle 1.0 W Shock g 100 | 300 seek W Rotation RPM 4000 read/write W Acoustic dBA 30 spin-up 2.2 W ECC Bit SMART MTBF h 300000 Warranty Month Lift/Lock/Park YES Certificates ********************************************************************** L A Y O U T ********************************************************************** FUJITSU M2723T JUMPER SETTING +--------------------------------------------------------+ | |XX | |XXI | |XXN | |XXT | |XXE | |XXR | |XXF | |XXA | |XXC | |XXE | |XX | |XX | 1XX | |xxJumper +--------------------------------------------------------+ ********************************************************************** J U M P E R S ********************************************************************** FUJITSU M2723T JUMPER SETTING Jumper Setting ============== +CNH1--1-----Interface--------- MASTER DEVICE |* * * * * * * * * * |* * * * * * * * +------------------ +CNH1--1-----Interface--------- SLAVE |* * * * * * * * * * |xxx * * * * * * +B-D---2----------- +A-C---1-----Interface--------- CABLE SELECT |xxx * * * * * * * * |* * * * * * * * CSEL signal is enabled +------------------ The CSEL setting is not depended on setting between pins B and D. By connecting the CSEL of the master device to the CSEL Line (conductor) of the cable and connecting it to ground further, the CSEL is set to low level. The device is identified as a master device. At this time, the CSEL of the slave device does not have a conductor. Thus, since the slave device is not connected to the CSEL conductor, the CSEL is set to high level. The device is identified as a slave device. ********************************************************************** I N S T A L L ********************************************************************** -ANY DIREC. Notes on installation ===================== Installation direction ---------------------- horizontally vertically +-----------------+ +--+ +--+ | | | +-----+ +-----+ | | | | | | | | | +-+-----------------+-+ | | | | | | +---------------------+ | | | | | | | | | | | | | | | | | | +---------------------+ | +-----+ +-----+ | +-+-----------------+-+ +--+ +--+ | | | | +-----------------+ The drive will operate in all axis (6 directions).