DATA TECHNOLOGY CORPORATION
DTC6180-15TX (REV. B)
| 
 Data Bus  | 
 16-bit ISA  | 
| 
 Card Size  | 
 Full-length, full-height card  | 
| 
 Hard Drives supported  | 
 Two ESDI drives with 17 or 60 sector mapping  | 
| 
 Floppy drives supported  | 
 None  | 
| 
 Sector interleave  | 
 1:1  | 
| 
 CONNECTIONS  | |||
| 
 Function  | 
 Location  | 
 Function  | 
 Location  | 
| 
 34-pin cable connector - hard drive  | 
 J2  | 
 20-pin data cable connector - drive 1  | 
 J4  | 
| 
 20-pin data cable connector - drive 0  | 
 J3  | 
 4-pin connector - drive active LED  | 
 J5  | 
| 
 USER CONFIGURABLE SETTINGS  | |||
| 
 Function  | 
 Label  | 
 Position  | |
| » | 
 Wait state disabled  | 
 W2  | 
 Open  | 
| 
 Wait state enabled  | 
 W2  | 
 Closed  | |
| » | 
 BIOS SRAM is 2Kx8 (6116)  | 
 W3  | 
 Open  | 
| 
 BIOS SRAM is 8Kx8 (6264)  | 
 W3  | 
 Closed  | |
| » | 
 Track buffer size is 32Kx8 SRAM  | 
 W4  | 
 Pins 1 & 2 closed  | 
| 
 Track buffer size is 8Kx8 SRAM  | 
 W4  | 
 Pins 2 & 3 closed  | |
| » | 
 Factory configured - do not alter  | 
 SW1/1  | 
 On  | 
| » | 
 Primary port address (1F0h-1F7h) enabled  | 
 SW1/2  | 
 Off  | 
| 
 Secondary port address (170h-177h) enabled  | 
 SW1/2  | 
 On  | |
| » | 
 Auto-deselect disabled  | 
 SW1/3  | 
 Off  | 
| 
 Auto-deselect enabled  | 
 SW1/3  | 
 On  | |
| » | 
 BIOS EPROM enabled  | 
 SW1/4  | 
 On  | 
| 
 BIOS EPROM disabled  | 
 SW1/4  | 
 Off  | |
| » | 
 Interrupt after reset enabled  | 
 SW1/7  | 
 On  | 
| 
 Interrupt after reset disabled  | 
 SW1/7  | 
 Off  | |
| » | 
 Track buffer enabled  | 
 SW1/8  | 
 On  | 
| 
 Track buffer disabled  | 
 SW1/8  | 
 Off  | |
| 
 BIOS ADDRESS SELECTION  | |||
| 
 Address  | 
 SW1/5  | 
 SW1/6  | |
| » | 
 C8000h  | 
 Off  | 
 Off  | 
| 
 D0000h  | 
 Off  | 
 On  | |
| 
 D4000h  | 
 On  | 
 On  | |
| 
 D8000h  | 
 On  | 
 Off  | |